In my previous post I mentioned the way to create a USB/ISO for booting / installing the ASDK system. Now I’ve automated the creation of the ISO image (so you don’t have to) and with Microsoft buying GitHub, I also pushed all the code onto GitHub as well. In there you will find the following […]
When you have deployed your ASDK in ADFS mode and you want to shutdown/reboot the host, you might notice that the service never comes up again.. while a shutdown through the host directly is not-supported you are able to shutdown the ASDK using the AzS-ERCS01 privileged endpoint. To shutdown your ASDK do the following from […]
(Not supported by Microsoft alert!) Azure Stack uses Active Directory technologies for identity management and authentication. By default, Azure Stack has 2 modes in can operate in. It can be used in a AAD mode utilizing Azure Active Directory for identity permission assignment as well as federated authentication or it can be setup in the […]
If you want to deploy the Azure Stack Development Kit, the deployment guide instructs you to install a clean Windows 2012R2 or 2016 server OS on the physical host to then configure it to boot from the CloudBuilder VHDX on the C drive. In this blogpost the initial installation of Windows 2012R2 / 2016 is […]
I know that many of my posts are about networking icw a Juniper SRX… as I happen to have one. But what if you don’t have such a “sophisticated” device that can handle multiple virtual routers, BGP and all the other stuff. Well I could say, buy one from e-bay.. but let’s see if I […]
When you have Azure Stack Development Kit deployed and in Routing mode (see earlier post). You can now also create S2S VPN connections to the tenants deployed inside Azure Stack. In my configuration I used BGP for the BGPNAT to advertise the newly assigned “external” IP addresses to my Juniper so that I don’t have […]
When you have your Azure Stack Development Kit, you might want to show it off to your customers or simply change the external IP address for some other reasons.. as we have seen earlier there is a dual NAT mode inside the Azure Stack Dev Kit box. The AzS-BGPNAT01 VM receives an external IP address […]
If you are playing around with Azure Stack Development Kit, you might come across the following error: While the error states: Unable to place Virtual Machines for specific class and size due to low memory capacity my immediate thought was to check the memory utilization on the host: With over 73Gb of memory left, I […]
Now that we have our Azure Stack Development Kit in routing mode, we can also send the BGP information from within the Stack to the Juniper Firewalls (or any FW you have..). This will ensure that the new “external IP addresses” that are assigned to our workloads are accessible via our intranet route information and […]
When you install Azure Stack Development Kit it is a completely isolated service with multiple networks. It means that your Azure Services (such as ADFS, the portal and AD) are not available outside of the box at all. But what if you wanted to use the Azure Stack DK from multiple computers? or in our […]